DAF VIC ECU Programming with VCI560 DAVIE

 Want to swap the memory of broken vic3 from DAF to working vic3, and have no idea how to connect vic and what the hardware to program, read the following paragraphs.

 

You can program on table with DAVIE. both, VCI560 (higher price) and DAF VCI lite (much lower price) will do the job. It is quite easy You must have the same VIC3 number. Or the same year of production.

Just look at pinouts, you need stable +19-28V; ignition pin, ground pin, and diagnostic CAN H and CAN L or you can make same brutalforse. Brutalforse would invove having a programer (or building one) to read main MCU, which is Fujitsu MB9xFxxx and eeprom memory and transfering it to new donor, if the SW is not damaged in original.

Program DAF VIC3 with DAVIE 1

 

Example:

How to Program DAF VIC computer with DAVIE XDc II software?

 

This is DAVIE XDc II software, and I will show how to program.

Program DAF VIC3 with DAVIE 2

Key off.

Program DAF VIC3 with DAVIE 3

Then you connect on your DAF.

Your DAF doesn’t connect because your keys off even the brake you can see the lights are off.

Program DAF VIC3 with DAVIE 4

Program DAF VIC3 with DAVIE 5

Then you put the chassis number there: OE684037.

After that, you connect it and the it will give you fault number:200.45, because there’s nothing happening there, then you come here you turn your key on, as you can see we have our chassis number already.

Program DAF VIC3 with DAVIE 6

Our new chassis number, then you say cancel them.

Continue the procedure.

Program DAF VIC3 with DAVIE 7

Okay, we do not read fault codes.

We go to VIC.

Program DAF VIC3 with DAVIE 8

To program…

Basic software & parameters.

Program DAF VIC3 with DAVIE 9

Choose “VIC – programming basis software & parameters”.

Click “OK” to start programming.

Program DAF VIC3 with DAVIE 10

Reading customer parameters from the ECU and saving them into the logfile, please wait.

Program DAF VIC3 with DAVIE 11

Click on “Yes”.

Program DAF VIC3 with DAVIE 12

Several parameters can be set to default. Click on “OK”.

Program DAF VIC3 with DAVIE 13

Program DAF VIC3 with DAVIE 14

Calibration is running.

So this is what we’re dealing with today.

It will flash that red light there.

Program DAF VIC3 with DAVIE 15

Parameterization.

Parameterization is running.

Program DAF VIC3 with DAVIE 16

Basis software & parameters have been programmed successfully.

Program DAF VIC3 with DAVIE 17

Switch off contact.

Program DAF VIC3 with DAVIE 18

Yes to restore the following PTO hour counter values.

Program DAF VIC3 with DAVIE 19

Alright, we are done programming. Check ECU information.

Go to “VIC -ECU information” to read and save.

Program DAF VIC3 with DAVIE 20

Program DAF VIC3 with DAVIE 21

Program DAF VIC3 with DAVIE 22

Done.

 

Do you still think DAF VCI Lite (V1) is expensive? It can do more than diagnosis.

http://blog.obdii365.com/2021/06/17/program-daf-vic3-with-davie/

Share This Post

site by bcz