How to Fix v84 iProg+ Clone to work with All Adapters?

Here’s the customer solution to v84 iprog+ pro clone programmer RFID and UART/BDM adapters not working, only eeprom adapter working problem.

You are at your risk.
fix-iprog-clone-1

fix-iprog-clone-2

fix-iprog-clone-3
How to fix iprog pro?
fix-iprog-clone-4

fix-iprog-clone-5
Remove case of iprog
Check GND PIN case
fix-iprog-clone-6

fix-iprog-clone-7
This pin give -12v output and it must be 5V
fix-iprog-clone-8

fix-iprog-clone-9
This pin give 11.5V output. Must be 12V output.
fix-iprog-clone-10
Remove the upper power board of iprog
fix-iprog-clone-11
Testing the power board and it work fine
fix-iprog-clone-12
Removing the eboxy by hotair and sculpt tool
fix-iprog-clone-13

fix-iprog-clone-14
found the problem in the resistor (marked red arrow), change it with 4.7k Ω
fix-iprog-clone-15
finally iprog+ work fine with all adapters.
Done.

Share This Post

site by bcz