How to make 2009 Chevrolet HHR key fob with Tech2 clone

Success! Have tested Tech 2 clone for 2009 Chevrolet HHR key fob!

The detail… Here you go.
Install the GM Tech 2 scan tool
Turn ON the ignition with the engine OFF
Power On the Scan Tool
Hit Enter
Main Menu > F0: DIAGNOSTICS
2009-chevrolet-hhr-key-program-tech2-1

Vehicle identification – Model Year > (9) 2009
2009-chevrolet-hhr-key-program-tech2-2

Vehicle identification – Product Type > Passenger Car
2009-chevrolet-hhr-key-program-tech2-3

Vehicle identification – Product Make > (1) Chevrolet
2009-chevrolet-hhr-key-program-tech2-4

Vehicle identification – Product Line > A
2009-chevrolet-hhr-key-program-tech2-5

Diagnostics > F1: Body
2009-chevrolet-hhr-key-program-tech2-6
2009-chevrolet-hhr-key-program-tech2-7

Body> F5: Remote Control Door Lock Receiver
2009-chevrolet-hhr-key-program-tech2-8
Remote Control Door Lock Receiver > F5: Module Setup
2009-chevrolet-hhr-key-program-tech2-9
Module Setup > F1: Program Key Fobs
2009-chevrolet-hhr-key-program-tech2-10

Program Key Fobs > F0: Invalidate all key fobs
2009-chevrolet-hhr-key-program-tech2-11
Instructions:
The procedure will replace the previously programmed key fob with the key fob requiring programming.
(Follow Instructions, if it don’t work repeat entire procedure)
2009-chevrolet-hhr-key-program-tech2-12

2009-chevrolet-hhr-key-program-tech2-13

2009-chevrolet-hhr-key-program-tech2-14
All desired key fobs must be present.
When the first key fob is programmed, the module will erase the rest of the slots.
The module will fill slots until [Done] or [Exit] is selected.
Note: Only select [Start] once. If the procedure is started again, the control module will start over.

Share This Post

site by bcz