How to use Ncs Expert to disable TPMS on BMW E90

Car: BMW 2008 328xi e90

Purpose:

kill tpms and enable FTM

 

Procedure:

** Disconnect RDC Module above battery in trunk behind insolation **
1) NCS EXPERT, FILE, PROFILE, EXPERTMODE
2) F1 (vIN, ZCF/FA)
3) F3 (ZCS/FA F. ECU)
4) SELECT CHASSIS
5) CAS, (VIN SHOULD POPULATE), OK
6) F2, ENTER FA
7) SELECT CHASSIS, AGAIN
8) CLICK ON $2VB, HIT DELETE KEY ON KEYBOARD AND PRESS OK
9) F6, BACK
10) F4, PROCESS ECU
11) SELECT CAS, AGAIN
12) F2, CHANGE JOB, SELECT FA_WRITE
13) F3, EXECUTE JOB
14) F1, SG/SGEN, SELECT NFRM
15) F3, EXECUTE JOB

For e90 328xi 2008 i had to recode VO’s for NFRM and CAS

**TO WRITE TO ANOTHER MODULE,
-F1 (SG/SGEN), THEN F3, EXECUTE JOB.
_________________________________________
RECODE/RESET affected modules to enable FTM

1) For my car i had to reset BDSC, CAPPL (PRE LCI NAV CCC) AND KOMBI. Yours may include DSC/CIC (LCI NAV)

Module Reset Instructions
1 – Launch ncs expert and load the expert profile
2 – Press F1, then F3, choose your car chassis from the list and press ok. Next Press F6 to go back
3 – Press F4 and choose ecu/module you want to reset and press ok
4 – Press F2 and choose SG_CODIEREN and press ok
5 – Press F3 to execute job

2) USING EXPERTMODEN, CHANGE RDC_ALIVE TO NICHT_ATKIV IN KOMBI

 

http://www.obdii365.com/wholesale/bmw-inpa-k-can-with-ft232rq-chip.html

Share This Post

site by bcz